TM R1 Jetting advice w/ Data

[inopadd]

And what’s your setup now? Always mention this as we do not know what your currently using?

[Simone_Perego (SP)]

I will take full credit for introducing you to the K6 and will now rename myself “K6 Daddy”

[Andy_DiGiusto]

@Andy_DiGiusto

n what you are currently running now. Did you do an RPM test on the stand? When you run the engine, did it feel sluggish on the top (e.g. difficulty extending through top range) or sluggish in the middle (going from low to top). That will give you a good direction where to go.

How many RPMs were you hitting at full? Given all this, try drop the needle 1 slot and open up the air screw by 1/4-1/2. If it doesn’t improve, you probably need a much smaller atomizer, assuming you want to keep the K6